Kkkkkk, about the photo you posted below.. It seemed like you were having a hard time emotionally because of your glabella, so I slightly lowered your glabella with Photoshop~~ You look fine now too, but this also looks good~~ But will the glabella come down to about this level in the future???? This level looks nice~~ I also wish my glabella would come down a bit... it will come down, right?
No replies yet.
More in this category
Nose Surgery Reviews@rhino-reviewFeb 13 It's been 1 year since my nose surgery.
It's now been over 1 year since I had my nose done, and it's too natural I did tell the doctor to absolutely make it not obvious and as natural as possible But there isn't really that much difference from my old nose... I want to make it…
Nose Surgery Reviews@rhino-reviewFeb 12 Removing stitches!!!
For my hump nose, crooked nose, and tip (septal cartilage), the bridge was done with silicone!! Because of the osteotomy, I removed the tape after 8 days and got the stitches out after 10 days, earlier than other people. Today is the 10th…
Nose Surgery Reviews@rhino-reviewFeb 12 I had revision rhinoplasty. Which parts of the swelling go down?;;;
Like the person below, if the bridge is high in a straight line, I don't mind even if the glabella is high... But my original nose was very low, so in the pre-op photo on the right too, the nose was low and the middle was sunken…
Nose Surgery Reviews@rhino-reviewFeb 12 s
s
Nose Surgery Reviews@rhino-reviewFeb 12 When does the swelling go down? Where is the swelling located?
The drawing is weird, but as in the picture, when you have nose surgery~ When silicone is inserted into the nose, is the swelling in part 1? Or in part 2??? I used to think it was usually in part 1, but when I touch it, it feels like I can
Nose Surgery Reviews@rhino-reviewFeb 12 Day 21 after hump nose surgery~ Do I need revision surgery??
The one photo at the top is before surgery. The two photos below are the right and left views after surgery For my hump nose surgery, I had osteotomies of the bones on both sides and the protruding area, and it was raised with 1 mm Gore-S